PNB Hema Free Base, 8 ml

HEMA FREE Base is maximum comfort and safety for clients with any nail plate, and especially for people with hypersensitive nails. Due to the consistency of medium viscosity, the material is well distributed over the surface with minimal effort by the master. As a result, you get a super-durable coating of medium hardness. Rubber HEMA FREE Base 一 is a guarantee of safety for the master and the client.

ADVANTAGES:

• modernized warehouse;
• lack of HEMA monomer in the composition;
• tested on allergy sufferers;
• super adhesion;
• flexibility and moderate stiffness;
• hypoallergenic formula 12 FREE;
• during polymerization, the exothermic reaction is less pronounced;
• does not heat up to high temperatures on the nails, does not cause unpleasant sensations during polymerization;
• suitable for thin, damaged and sensitive nail plate;
• perfect consistency for straightening nails;
• a wide range of possibilities: strengthening, restoration, extension of the free edge/corners up to 2 mm in length;
• ultra-durable coating, without chipping and peeling for up to 28 days.

THIN APPLICATION. APPLICATION METHOD:

1. Prepare the nail plate with PNB buff, remove the gloss.
2. Apply the auxiliary liquids: Nail Dehydrator and Bond Control to the entire plate.
3. Apply a very thin layer of HEMA FREE Base PNB, seal the free edge, dry for 60 sec.
4. Apply a thin, even layer. Polymerize in the lamp for 60 seconds. Remove stickiness with PNB Gel Cleanser as needed.
5. Do the coating/design, apply the PNB top.

LEVELING TECHNIQUE. APPLICATION METHOD:

1. Prepare the nail plate with PNB buff, remove the gloss.
2. Apply the auxiliary liquids: Nail Dehydrator and Bond Control to the entire plate.
3. Apply a very thin layer of HEMA FREE Base PNB, seal the free edge, dry for 60 sec.
4. Apply a second very thin layer of HEMA FREE Base PNB, place a drop of base on the highest point of the nail and stretch it evenly to the free edge.
5. Polymerize in the lamp for at least 1.5 minutes.
6. If necessary, remove the sticky layer with Gel Cleanser PNB.
7. Complete the cover design, apply the PNB top.

RECOMMENDATIONS:

• for the absence of sensations, the coating thickness should not exceed 1 mm;
• when leveling the nail plate, the thickness of the coating should not exceed 1.5 mm for complete polymerization of the product. It is recommended to work in a conveyor way, polymerizing each nail for a few seconds, and at the end 一 complete drying for 1-2 minutes, depending on the type of lamp and power;
• the exothermic reaction is more pronounced in the summer at temperatures above 25 degrees. To avoid this, it is desirable to have an air conditioner in the workplace;
• you can also use Low Heat Mode.